User's Manual

Smart Machine Smart Decision
1.2 Summarize the specific operational use conditions
None.
1.3 Limited module procedures
None.
1.4 Trace antenna designs
Refer to sections 4.2 and 4.3.
E. INTEGRATION INSTRUCTIONS
1.1 List of applicable FCC rules
FCC Rule Part 22H，FCC Rule Part
24E，FCC Rule Part 27
and FCC Rule Part 90
1.2 Summarize the specific operational use conditions
None.
1.3 Limited module procedures
None.
1.4 Trace antenna designs
Refer to sections 4.2 and 4.3.
1.5 RF exposure considerations
For the product,under normal use condition is at least 20cm away from the body
of the user,the uer must keeping at least 20cm distance to the product.
1.6 Antennas
GSM/UMTS/LTE main antenna,UMTS/LTE auxiliary antenna and GNSS antenna.
A
ntennas type：monopole
1.7 Label and compliance information
If the host is marketed so that end users do not have straight forward commonly
used methods for access to remove the module so that the FCC ID of the module
is visible; then an additional permanent label referring to the enclosed module:
Contains Transmitter Module FCC
ID: 2AJYU-8FCA101
1.8 Information on test modes and additional testing requirements
Refer to sections 5.3.
1.9 Additional testing, Part 15
Subpart B disclaimer
The module only complies with the FCC Rule Part 22H，FCC Rule Part 24E ， FCC
Rule Part 27and FCC Rule Part 90.If the module is installed in the host device,
the host manufacturer is responsible for the compliance to any other FCC rules
that apply to the host not covered by the modular transmitter grant of
certification. For example, if the host manufacturer markets their product as
being Part 15 Subpart B compliant (when it also contains unintentional-radiator
digital circuity), then the host manufacturer shall provide a notice stating
that the final host product still requires Part 15 Subpart B compliance
testing with the modular transmitter installed.