User Manual

Power on the SimCam Alloy 1S

Screw the antenna to coax end at the bottom of the camera.

Plug the power cable into the DC power port on the back of the

camera. Plug the AC adapter into a 100-220V AC power outlet.

The status LED will blink red indicating that the camera is

powered on.

After a minute or two, the status LED will blink green indicating

that it is ready to connect to WiFi.

Insert the power cable into the

slot. Put the rear cover back on

and secure it with screws.

Tip: If the light does not blink green, please press the reset button and

hold it for 5 seconds to reset the device.