User's Guide

P/N R63314 v1.08c
Page | 24
• InSite Overliner(s)
• InSite Setup Form(s) and pen or pencil
RIDDELL REVOLUTION SPEED
The following instructions apply to Riddell Revolution Speed helmets.
For other Riddell helmets please refer to www.riddell.com
.
Riddell recommends that the Revolution Speed helmets installation
video is viewed prior to installation. Visit www.riddell.com/innovation
to
find this video.
1) Remove original Overliner and S-pads (face pads)
a) For the first installation of an InSite retrofit, begin by removing
the standard Overliner from the helmet. Use the Phillips
screwdriver to remove the upper facemask attachment screws.
Rotate the facemask forward and remove the original Overliner.
b) Remove original S-pads (face pads) from helmet.
2) Assemble InSite Player Unit to InSite Overliner
Note: New InSite Player Units are shipped pre-assembled to InSite
Overliners. For new installations, proceed to step
3). The following
procedure is used to re-assemble the Player Unit and Overliner after
washing the Overliner.