User's Guide

P/N R63314 v1.08c Page | 40
6) After all player and equipment assignments have been completed in
the software, connect an Alert Monitor to the computer if not
currently connected.
7) If the “SYNC REQUIRED” button is showing in
the upper right hand corner of the window,
click on the button to synchronize the Alert Monitor.
Note: This button can be seen on all InSite Player Management
software screens.
Follow the directions on the pop-up window to finish setting up this
team’s equipment, and then click “OK”.
8) If prompted, plug in the additional (2
nd
) Alert Monitor for this team
and repeat step 6) above.
9) The “SYNC REQUIRED” button will change
after all Alert Monitors on this team are up
to date.
The button will now remain in this state until changes are made to
the team’s players or equipment assignments, at which time the
button will change back to “SYNC REQUIRED”.
10) Press the Power button on the Player Unit once to turn it on. The red
LED will flash four times to indicate the Player Unit is powered on.
Note: Alternatively, if already on, the yellow LED will light while the
button is depressed, and Player Unit will remain on after button
release.
11) If you haven’t already done so, command a directed check-in of
specific Player Units as required (see Check In Player Units, p.51).