User's Guide

P/N R63314 v1.08c Page | 20
1) Power button
 Power on - Press for one second. The red LED will blink four
times to indicate startup. Alternatively, if already on, the yellow
LED will light while the button is depressed, and the Player Unit
will remain on after button release.
 Power off (deep sleep) - Press and hold for ten seconds until the
yellow LED “blinks off” for the second time, then release. Red
and yellow LEDs blink alternately to indicate Player Unit turning
off.
 Test mode - Press and hold for six seconds until the yellow LED
blinks off, then release. The red and yellow LEDs will blink six
times alternately, indicating test mode (see Sending Test Alerts
(Test Mode), p.70).
Note: Do not press and hold power button for longer than fifteen
seconds, as the unit will enter a button lock-out state and be
unresponsive for five to ten minutes. This feature prevents
accidental turn-off during on-field use.
2) Check-in button
 Configuration mode - To add a Player Unit through the player
management software, when prompted, press and hold for five
seconds until the yellow LED blinks rapidly (signaling
configuration mode), then release.
 Check-in function – To command the Player Unit to check in
with the Alert Monitor, press and hold for two seconds until the
red LED blinks off once, then release. The yellow LED will flash