User's Guide

P/N R63314 v1.08c Page | 19
EQUIPMENT GUIDE - PLAYER UNIT
BATTERY CARE
InSite Player Units are powered by a factory-installed non-rechargeable
battery. The Player Unit’s battery must be replaced once each year
during reconditioning by a Riddell factory-authorized reconditioning
center. Please call Riddell Customer Service at [phone] for the
factory-authorized reconditioning center nearest you. Failure to replace
the battery each year will result in loss of power and the Player Unit will
become inoperable.
The Alert Monitor ‘VIEW ERRORS’ menu will display a low battery
message for affected Player Units that remain operating. Player Units
with loss of power will not check in with the Alert Monitor, and will
appear on the ‘VIEW ABSENT’ menu.
CONTROLS AND INDICATORS
The Player Unit transmitter is located in a protective pouch in each
InSite Overliner. It is used to transmit impact data to the Alert Monitor,
and is connected to the sensor pad. The Player Unit has two basic
states while powered on – active and sleep. The Player Unit will manage
its own power state to maximize battery life based on recent activity
detected by a motion sensor. The Player Unit can also be placed in a
Deep Sleep or “off” condition for shipping or end of season storage.
The two buttons on the player unit are used to place the unit into several
different states and functionality modes based on which button is
pressed and how long it is held. A summary table of button commands
and LED feedback is located at the end of this section (see Summary of
Player Unit Button Commands and LED Feedback, p.22).