Instruction Manual
2.4GHz
FCC ID : 2AZLL109413509
2.4GHz
FCC ID : 2AZLL109413509B
Controller MLA RC Scooter
Please keep this address and the instructions for use.
Not suitable for children under three years.
Choking hazard! Small parts may be swallowed!
Strangulation hazard due to the long cord and long cable!
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. Caution: Changes
or modications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, maybe cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent form
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radio Controlled Scooter
10 11 12 13 14 1
ONOFF
Batteries for controller
Important information — please retain! Only use the batteries (2x1,5V LR03/AAA) specied! Put
positive and negative pole in the right place! Do not throw away used batteries in the household
garbage, but only give them to the collection station or dispose of them at a special garbage
depot. Remove empty batteries from the toy. Non-rechargeable batteries must not be recharged.
Before charging remove rechargeable batteries from the toy. Rechargeable batteries must be
charged under adult supervision only. Do not use dierent types of batteries and do not mix new
and used batteries. Do not short-circuit connecter clips. Do not mix old and new batteries. Do not
mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
Bluetooth® Technical Specication
Bluetooth® Version: 5.0
QDID: 110839
Design model no. : AC6911
Battery type: Built in Lithium-ion battery 7.4V 600mAh
OS support: IOS 14.0 or above; Android
Bluetooth® frequency band: 2.4GHz
Operation range: up to 10 meters line-of-sight in an open and clear environment.
Battery Disposal (MLA RC Scooter)
Lithium-Ion-batteries - Use and safety information General information: Lithium ion batteries are
energy storage devices with a very high power density and are therefore potentially dangerous.
They must be handled with great care during charging and discharging as well as when storing or
handling for other reasons. Carefully read these instructions before using the battery for the rst
time and pay special attention to the use and safety information. This will protect you and prevent
damage to the product. Misuse increases the risk of explosion, overheating, re, etc. Failure to
observe the use information can cause premature wear or other defects. Safety information: -
Avoid short circuits. A short circuit can destroy the product in some cases. Cables and connections
must be well insulated. - Always ensure the correct polarity. Always ensure that the battery is
connected properly to the charger or model/device. - Do not cut or modify original connectors and
cables. - Do not expose battery to excessive heat/cold or direct sunlight. Never throw into re. Do
not let the battery come into contact with water or other liquids. - Only use approved chargers.
Never use NiCd/NiMH chargers! This comes to overcharging and poses the risks mentioned above.
- Allow battery to cool to ambient temperature before charging. Never charge a hot battery. - Do
place the battery on an inammable, heat resistant surface when charging. Do not place the
battery near highly ammable objects. Never leave battery unattended during charging or
operation. - Do not use the battery if the casing is damaged. Always prevent damage caused by
sharp objects such as knives or similar, dropping, bumping, bending, etc. Discontinue use if battery
is damaged! - Always ensure when inserting the lithium-ion-battery into your model that is cannot
be damaged or deformed even in case of a crash or fall. Damage to the battery makes it unusable.
- Batteries are not a toy. Keep it away from children. Always store out of reach of children. Storage
information: Before longer storage the battery must be fully charged. At least all six month the
battery have to be one time discharged (drive empty) and charged fully again before storage.
Otherwise, the battery will lose its capacity and will become defective. Disposal information:
Batteries are hazardous waste. Dispose of damaged or unusable cells properly.
This transmitter is equipped with 2.4GHz technology, which allows up to 6
vehicles to be used at the same time. To sync transmitter and vehicle, follow
these steps:
1) Install batteries in Controller.
2) Turn on RC Scooter.
3) Once the batteries are installed and the RC Scooter is turned on, the Controller will
sync automatically with the RC Scooter.
Batteries
Charging the Scooter via USB cable
This RC Scooter is equipped with an internal Lithium-Ion battery that is rechargeable via
USB. Charging can be done in all ON / OFF / Bluetooth modes. Scooter will not
function in charging mode.
1) The charging cable is located inside a compartment beneath the seat. (Location
'H' shown below)
2) Lift up the seat by pressing the back of the seat while lifting it up.
3) Open the storage compartment cover by removing the screw.
4) Remove USB cable from the compartment. (Be gentle when extending the USB cable
as it is attached to inside battery.)
5) Insert the USB connector into a computer or other USB power source (not provided).
6) The USB plug will ash red when charging. When charging is completed, the red light
stops ashing and stays still. A full charge would take approximately 180 mins.
7) Return cord and secure storage lid before operating the scooter.
8) Playing time: approximately 30 mins after fully charged
®
Caution and Care
Proper Use And Care
- Wipe with soft rag or cloth.
- Do not use chemicals or water to clean.
- Brush areas where dirt get trapped.
- Switch vehicle to OFF when not in use.
- Do not leave out in the sun.
- Do not run into hard objects.
- Do not drive on sand.
- Do not get wet.
Caution!
- Do not recharge internal Battery if vehicle is hot or warm to the touch. Allow
Battery to cool before charging. Recharging a hot or warm Battery will shorten the
life of the unit.
- Do not recharge the Internal Battery if it appears to be damaged or leaking.
- Always store charging cord in storage compartment when not in use.
- Do not dispose batteries in re. Leakage, explosion and personal injury may occur.
- Do not attempt to disassemble or remove Internal Battery or charging cord.
- Only an adult should charge Batteries.
- Do not attempt jumps or tricks with this vehicle.
Support
FAQ
1. The scooter tips over with doll riding on it.
Please ensure the doll is holding the handle with both hands and is not leaning to
one side.
If problem persists, ipping out the Stabilizing wheels on the scooter base should
help. (Refer to Vehicle Feature - Stabilizing wheels)
2. Why the headlamp on scooter keeps ashing?
When the RC Scooter is not connected to the controller, the headlamp will ash
continuously. Simply power on the controller, it will connect with the RC Scooter
automatically.
3. Why the scooter turns o itself after a while?
To conserve battery, the scooter will Auto-o after 2 mins of inactivity.
You can turn on the scooter by rst switching its power button to O and then On.
FCC and Bluetooth®:
FCC Caution:
Changes or modications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Batteries
Batteries in Controller
H
1
2
9
Vehicle Features
Bluetooth® audio. Connect to mobile device.
1) Switch the RC Scooter to " Bluetooth®" mode.
2) Enable Bluetooth® on your mobile device.
3) Select "MLA RC Scooter" from the device list.
Password: 1111
4) You will hear conrmation tone upon successful pairing.
5) Music played on your device can now be heard through scooter speakers.
®
ON
Searching...
®
2 x 1,5V
LR03 / AAA
109413509WMU
Distributed by Walmart Inc.,
Bentonville, AR 72716
On
Bluetooth
®
Of f