User guide

App User Guide
Firmware updates for MiND hardware
The 180 MiND can be updated directly from the network by following these steps:
(1) Take note of your network settings in your MiND App (refer to the MiND Setup Guide procedure), since a
firmware update will automatically reconfigure these settings back to their factory defaults.
(2) Close down the MiND app.
(3) Disconnect the DC power cable from the rear of the 180 MiND, but keep it connected to both your
network (wired or wirelessly) and the internet.
(4) Press and hold the “UPDATE” button located on the back panel (beside the “ETHERNET” cable input).
This will require a small pin since the button is slightly recessed behind the rear panel.
(5) While still holding the “UPDATE” button, reconnect the DC power cable to the 180 MiND and wait
for the “UPDATE” LED to begin flashing. Then you may release the “UPDATE” button.
(6) Allow the unit to reprogram itself; this automated process may take as long as ten minutes to complete.
The LED will only stop flashing, but stay illuminated once this process when finished.
(7) “Reboot” the 180 MiND by disconnecting the DC power cable again and waiting a few seconds, then
reconnecting the DC power cable. Now your unit is ready to use.
MOON components equipped with the MiND option (such as the 380D Digital-to-Analog Converter)
can also be updated directly from the network by following these steps:
(1) Take note of your network settings in your MiND App (refer to the MiND Setup Guide procedure), since a
firmware update will automatically reconfigure these settings back to their factory defaults.
(2) Close down the MiND app.
(3) Turn off the rocker switch (position ‘0’) located on the rear of your MOON component, but keep it
connected to both your network (wired or wirelessly) and the internet.
(4) Press and hold the “UPDATE” button located on the back panel (beside the “ETHERNET” cable input).
This will require a small pin since the button is slightly recessed behind the rear panel.
(5) While still holding the “UPDATE” button, turn on the rocker switch (position ‘1’) and wait for
the “UPDATE” LED to begin flashing. Then you may release the “UPDATE” button.
(6) Allow the unit to reprogram itself; this automated process may take as long as ten minutes to complete.
The LED will only stop flashing, but stay illuminated once this process when finished.
(7) “Reboot” your MOON component by turning off (‘0’) the rear panel rocker switch and waiting a few
seconds, then turning the rocker switch back on (‘1’). Now your unit is ready to use.
____________________________________________________________________________________
MiND User Guide 15