Owner`s manual

MOON i-5 Integrated Amplifier
Remote Control Operation
The MOON i-5 Stereo integrated amplifier uses the ‘SRM’ simple
function, all aluminum remote control (figure 3). It operates on the
Philips RC-5 communication protocol and is can be used with other
Simaudio MOON components such as the P-3 preamplifier and the
i-5080 integrated amplifier.
The ‘SRM’ remote uses three AAA batteries (included). To install
them, use the supplied Allen key to remove the three screws
located on the back plate; insert the batteries in the correct
direction and then screw the back plate back into place.
The POWER button located on the upper left will switch the
integrated amplifier to either ‘Stand by’ or ‘On’ mode.
The INPUT button performs in exactly the same way as the
‘Input’ button located on the i-5’s front panel, sequentially
cascading through each of the integrated amplifier’s inputs.
Figure 3: SRM Remote Control The VOL+ and VOL– buttons increase and decrease, respectively,
the volume level.
The  and  buttons control channel balance; Pressing the left
arrow button causes a decrease in the volume level of the right
channel; pressing the right arrow button causes a decrease in the
volume level of the right channel.
The MUTE button, located in the middle of the volume and balance
buttons, performs the identical function as the ‘Mute’ button located
on the i-5’s front panel.
____________________________________________________________________________________
Remote Control Operation 11