Manual
860A Dual-Mono Power Amplifier
____________________________________________________________________________________
7
Unpacking
The MOON 860A power amplifier should be removed from its box with care.
The following accessories should be included inside the box with your amplifier:
9
AC power cable
9
This owner’s manual
9
Warranty and product registration information (USA and Canada only)
Once the 860A is unpacked, inspect it thoroughly
and report any damage to your dealer immediately.
We suggest that you keep all of the original
packaging, storing it in a safe, dry place in case
you’re required to transport this product. The
customized packaging is specially designed to
protect the 860A from any potential damage during
transit.
Please write the serial number of your new MOON 860A in the space provided below for future reference.
Serial No.: ________________
Installation & Placement
The MOON 860A Dual-Mono power amplifier is
both powerful and heavy. It requires reasonable
ventilation to maintain an optimum and consistent
operating temperature, especially since it will radiate
heat when driven hard. Consequently, it should be
placed in a location with empty space around it for
proper heat dissipation. You should never place
another component on top of this amplifier. As well,
the amplifier should be placed on a solid level
surface. You should avoid placing it near a heat
source or inside a closed cabinet that is not well
ventilated as this could compromise the amplifier’s
performance and reliability. The 860A uses two
large toroidal transformers in its power supply; even
though they are well shielded, you should not place
this amplifier too close to source components
sensitive to EMI, such as turntables, phono
preamplifiers and CD Players.
If the surface you have chosen isn’t perfectly level,
each of the four (4) cones of your 860A are height
adjustable; carefully using your fingers, you can
either raise each leg by turning the cone underneath
clockwise, or lower each leg by turning it
counterclockwise.
We strongly recommend that you leave these cones
mounted to the component at all times for reasons
related to both performance and aesthetics.