Installation manual

11
E
SC
MEN
U
AU
T
O

These allow navigating in the menus of
the On Screen Display and parameter
adjustments.
 turns on in stand-by and recalls the
Input Selection menu.
 (if pressed in the absence of the On
Screen Display) makes the information
window INFO appear
MENU
Activates the On Screen Display and allows
navigating through its pages.
ESC
Deactivates the On Screen
Display
AUTO
Recalls the automatic function for
optimising the image projected on the
screen.
KEYPAD
+
-
+
-
+
-
+
-
4 1.5 V AAA-type
batteries.
The keypad on the back of the Display comprises eight keys
that allow complete control of the device even in absence of
the remote control.
REMOTE CONTROL
The remote control sends commands to the system by means
of infrared rays.
There are two receivers, located on the front of the Display and
on the front panel of the DigiOptical Image Processor.
Do not interpose obstacles between the remote control and the
receivers: this could render the remote control ineffective.
The remote control operates with four 1.5 V AAA-type batteries.
Insert the batteries carefully, respecting the polarity, as shown
inside the battery compartment of the remote control itself (Fig.
10).
Replace the batteries when you notice the remote control losing
its effectiveness.
Remove the batteries if the remote control is not being used for
a long period, in order to avoid any chemical leaks that could
damage it.
Put the system in stand-by mode.
Do not turn the power switches of the units to the “O” position
and do not disconnect the power supply cables immediately after
Fig. 9
Fig. 10
putting the system in stand-by mode, but wait at least one minute.
This is to allow the fans in the Display unit to cool the lamp.