Installation manual
9
DOMINO 55M power switch is on the rear panel (Fig.5).
I
O
Fig.5
Once the power switch is on the “I” position, the unit will initialise
and execute a test routine. Soon after the unit will enter stand-by
mode (Table 2).
Front panel LEDs placed show the status of the unit.
Table 2
If the status is “Error” the unit cannot be operated; if the status is
“Warning” the unit will operate but it may be unable to read certain
input signals correctly.
STAND BY
Switching On (Fig.6):
ME
NU
Fig. 6
• from the Remote Control (keys 0-7)
• from the front panel Keypad (keys
▲ and ▼)
Pressing a key from 1-7 on the remote control selects the corre
-
sponding input; pressing 0 (or one of the keys ▲ and ▼ on the front
panel) selects the input that was active at the time the unit was last
switched off. Typically, the picture will appear after 15-20 seconds. If
the unit is switched on soon after it was last switched off, the lamp
may fail to come on because it is too hot. In this case just wait a
few minutes to allow the lamp to cool.
Switching Off (Fig.7):
ME
NU
Fig. 7
• from the Remote Control (key
)
• from the front panel Keypad (key ).
4 SWITCHING ON AND OFF