Installation manual

4
ATTENTION:
To reduce the risk of electric shock, disconnect the power
supply cable on the rear panel before removing front (or
back) panel of the unit.
No user-serviceable parts inside. Refer to trained, autho-
rised personnel for technical assistance.
This symbol indicates the possible electric shock
hazard associated with uninsulated live components in the
interior of the unit.
This symbol indicates the presence of important
instructions regarding use and maintenance of the pro
-
duct.
2 IMPORTANT SAFETY INSTRUCTIONS
• Federal Communication Commission (FCC Statement)
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is used in a residential environment. This equipment
generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determinated by turning the equipment off and on, the user is encuraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
• For customers in Canada
This Class B digital apparatus complies with Canadian ICES-003.
• For customers in the United Kingdom
ATTENTION: This apparatus must be earthed
The wires in this mains lead are coloured in accordance with the following
code:
Green-and-Yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this apparatus may not
correspond with the coloured markings identifying the terminals in your
plug proceed as follows:
The wire which is coloured green-and-yellow must be connected to the
terminal in the plug which is marked by the letter E or by the safety earth
symbol or coloured green or green-and-yellow.
The wire which is coloured blue must be connected to the terminal which
is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which
is marked with the letter L or coloured red.
• Read each chapter of this manual carefully before operating your
unit. Keep this manual for future reference.
• Preliminary adjustments and procedures that necessitate the
removal of the front (or back) panel, must be carried out by
authorised, trained technicians. There are no user serviceable
parts inside.
• To ensure safe and long term reliability please use power cables
supplied with the unit. Observe all warnings and cautions.
• Do not touch internal parts of the unit.
The unit contain electrical parts carrying high voltages and ope-
rating at high temperatures. Do not remove the front (or back)
panel from the unit and refer to qualified service personnel for
all repair and maintenance requirements. The warranty will be
automatically invalidated if the cover is removed from the unit.
• Power supply disconnect device.
The device for disconnecting the unit from the mains power
supply is constituted by the power cable plug. Ensure that the
power cable plugs and the electrical mains socket outlets are
easily accessible during installation operations. To disconnect the
unit from the electric power supply, pull the plug to remove it
from the socket outlet. Do not pull the power cable.
• Use only the specified type of mains power supply.
Connect the unit to a power outlet with voltage rating between
100-240 VAC, 50/60 Hz and with a protective earth connection. If
you are unsure of the type of mains power supply in your home,
consult a qualified electrician. Ensure that the power draw of
the unit is commensurate with the rating of the electrical socket
outlets and any extension cables that are used.
• Protect the power supply cord.
Power supply cord should be routed so that it won’t constitute
an obstruction. Position the power supply cord where it cannot
be reached by children. Install the unit as close as possible to
the power outlet. Do not tread on the power supply cords and
make sure that they are not tangled or pulled; do not expose the
power cords to heat sources; make sure that the power supply
cords are not knotted or kinked. If the power supply cord or plug