Installation manual
15
OSD POSITION
Serves to position the On Screen Display within the screen area.
The OSD can be positioned using the arrow keys for fine adjust
-
ments or keys 1...9 on the remote control to select one of 9 preset
positions.
MEMORIES
The main picture parameters can be saved in discrete sets of values
called “
MEMORIES
” so that they can be subsequently applied as a
group using a single command.
3 separate Memories (Memory 1, Memory 2, Memory 3) are avai-
lable for each of the 14 types of signals:
for a total of 42 memories.
The image parameters that can be stored/retrieved by the Memories
management system are as follows:
Picture Image
BRIGHTNESS ASPECT
CONTRAST COLOR TEMPERATURE
COLOR COLOR TEMP. (R/G/B)
TINT OVERSCAN
SHARPNESS GAMMA
FILTER
SHARPNESS MODE
VIDEO TYPE
NOISE REDUCTION
Some of these parameters may not be available for certain inputs or cer-
tain input signals, in accordance with the definitions in Tables
3 and 4.
Fig.13
Text input mode is same whether you are editing an existing
name or entering a name for the first time. Characters can be
inserted in any of the available positions (represented by ho
-
rizontal lines). Use the
◀ and ▶ keys to move the cursor left
or right respectively. Press the numerical key corresponding to
the character (Fig. 13); the first press selects the first character,
the second press selects the second character, and so forth.
Once you have entered a character, to enter the next character move
the cursor to a position immediately to the right by means of the
▶
key control and repeat the procedure described above.
Use the ▲ key to switch from upper case to lower case characters.
To delete any errors move the cursor to the incorrect character and
press the ▼ key.
Once you have terminated the text input procedure confirm your
text and save it by pressing the
MENU+
key on the remote control.
If you want to cancel the changes you have made press the
MENU-
key.
SOURCE INFORMATION
When active (
YES
), each time the source is changed a box is displayed
with information relative to the signal type. When disabled (
NO
) this
box does not appear.
OSD BACKGROUND
Determines the type of background for the On Screen Display.
OSD TIMEOUT
Determines the On Screen Display timeout. When the On Screen
Display appears it will remain displayed for the time set in this
parameter starting from the time the last key was pressed. The
adjustment is made using the ◀ (decrease) and ▶ (increase) keys
within a 5-60 second timeframe.