Installation manual

ManualsBrandsSim2 ManualsProjection TVDOMINO 55M

If you wish to power off the unit completely, wait at least one mi-

nute in stand-by to allow the unit to cool before setting the mains

All the functions of the DOMINO 55M can be activated from the

keypad or remote control with the aid of a practical and comprehen-

sive system of on screen menus.

INPUTS

The input selection menu (

INPUTS

) is called by pressing 0 on the

remote control and, when no other menu is displayed, using the

▲ and ▼ keys on the keypad. To select an input, scroll through the

list with the

▲ and ▼ keys until the required input is highlighted,

then press ▶.

Display of the input selection menu is terminated by pressing the

ESC

key, or when the On-Screen Menu display timeout (set in the

Menu) has elapsed.

Inputs 3 and 4 can receive RGB and YCrCb signals, either at 15 kHz

or at 32 kHz or higher. The association between the input and the

type of signal is made from the pull-down menu that appears on

the right of the < symbol after pressing the

◀ key (Fig. 8).

In the pull-down menu it is also possible to select the AutoSync

option; in this case the DOMINO 55M automatically recognises the

input signal horizontal frequency (15KHz, 32KHz or higher).

After selecting the source signal (by means of the ▲ and ▼ keys),

press

MENU+/MENU -

to confirm and close the pull-down menu; the

value you have just entered will be displayed on the right of the <

symbol. As with the other inputs, you can now select the input just

set by pressing the ▶ key.

Inputs

1 VIDEO 1

2 S-VIDEO 2

3 COMP/RGB

4 COMP/RGB

5 GRAPH RGB 5

6 DVI-D 6

7 HDMI 7

YCrC

RGBS 15

kHz

Fig. 8A

Inputs

1 VIDEO 1

2 S-VIDE

O 2

3 COMP/RGB 3

4 COMP/RGB

5 GRAPH RGB

6 DVI-D 6

7 HDMI 7

YCrC

RGBS 15

kHz

YCrCb AutoSync

YCrCb 15KHz

YCrC

RGB AutoSync

RGB 15KHz

RGB

Fig. 8B

Also Input 6 (DVI-D) is capable of receiving YCrCb or RGB signals:

as above, the selection should be made from the drop menu that

appears on the right of the < symbol.

Once the input has been selected, a brief phase starts during

which the unit analyses the the applied signal. During this interval

a box appears with an indication relative to the signal requested.

As soon as the as the unit locks on to the signal and the picture is

displayed, a box with additional information may be displayed or

not, according to the value of “

SOURCE INFORMATION

” adjustment in

“

” section.

MAIN MENU

To access the main On Screen Display menu, press the

key

on the keypad or the

MENU+

MENU-

key on the remote control.

The main menu is divided into four windows,

PICTURE, IMAGE

SETUP

and

. Use ▲ and ▼ to select the line corresponding to the

adjustment you wish to make (Fig. 9).

The various menus offer only the relevant adjustments in accordance

with the type of input signal displayed (e.g. adjustments that are

typical of video signals do not appear on the menus when a signal

from DVI input is selected).

Some adjustments (e.g.

BRIGHTNESS

and

CONTRAST

) are associated

with a numerical value that can be varied within the set limits using

the ◀ and ▶ keys.

5 ON SCREEN MENU

power switches to the “O” position or unplugging the power supply

cables.