Installation manual
6
C3X LINK
7
• Be careful with cables.
Arrange cables in such a way that they will not cause any
obstruction.
Keep cables out of the reach of small children.
Install the units as close as possible to the wall electrical
socket outlet. Do not tread on the power cables, make
sure that they are not tangled or pulled; do not expose the
power cables to heat sources; make sure that the power
cables do not become knotted or kinked. If the power
cables become damaged, stop using the system and
request the assistance of an authorised technician.
• Read this manual and keep it safe
This manual contains important information on how to
install and use this equipment correctly. Before using the
equipment, read the safety prescriptions and instructions
carefully. Keep the manual for future consultation.
• Do not touch internal parts of the units.
The units contain electrical parts carrying high voltages and
operating at high temperatures. Do not remove the cover
from the units, refer to qualified service personnel for all repair
and maintenance requirements. The warranty will be auto-
matically invalidated if the cover is removed from the units.
• Disconnecting the appliance from the power supply.
The device for disconnecting the units from the mains
power supply is constituted by the power cable plug. Ensure
that the power cable plugs and the electrical mains socket
outlets are easily accessible during installation operations.
To disconnect the units from the electric power supply, pull
the plug to remove it from the socket outlet. Do not pull the
power cable.
• Connect the appliance only to the type of power supply
indicated
Connect the units to a mains electrical supply with rated
voltage of between 100-240 VAC, 50/60 Hz and equipped
with a protective earth connection. If you are unsure of the
type of mains power supply in your home, consult a qualified
electrician. Ensure that the power draw of the units is com-
mensurate with the rating of the electrical socket outlets and
any extension cables that are used. For the DigiOptic™ Image
Processor use exclusively the power supply unit provided or an
alternative power supply unit expressly approved by SIM2.
• Connection of the units to the mains power supply.
Make the connection as shown in Fig.1.
7BD
)[
^!#).
&53%
4
!(6^
%3#
3/52#%
PROTECTIONAGAINSTRISKOF
ONLYWITHSAMETYPEANDRATINGFUSE
!44%.4)/.POURNEPASCOMPROMETTRELAPROTECTIONCONTRELESRESQUES
DINCNDIEREMPLACERPARUNFUSIBLEDEMEMETYPEETDEMEMSCARACTERISTIQUE
0
I
7BD
)[
• Changing the fuses.
Before changing the fuse disconnect the unit from the
mains power supply.
The fuse compartment is near to the mains power con-
nector (Fig. 3). Remove fuse carrier (2) with the aid of a flat
blade screwdriver, then change fuse (3). Insert a new spare
fuse (4). Use only T 5A H fuses.
^!#).
&53%
4
!(6^
%3#
-%.5
3/52#%
FORCONTINUED
PROTECTIONAGAINSTRISKOF
ONLYWITHSAMETYPEANDRATINGFUSE
!44%.4)/.POURNEPASCOMPROMETTRELAPROTECTIONCONTRELESRESQUES
DINCNDIEREMPLACERPARUNFUSIBLEDEMEMETYPEETDEMEMSCARACTERISTIQUE
0
I
7
5")
Fig.1
Fig.2
Fig. 3
IMPORTANT SAFETY INSTRUCTIONS