Installation manual

C3X LINK
28
29
MEMORIES
The main picture parameters can be saved in discrete sets
of values called MEMORIES so that they can be subsequently
applied as a group using a single command.
3 separate Memories (Memory 1, Memory 2, Memory 3) are
available for each of the 25 types of signals:
for a total of 75 memories.
The image parameters that can be stored/retrieved by the
Memories management system are as follows:
Image Picture
BRIGHTNESS ASPECT
CONTRAST COLOUR TEMPERATURE
COLOUR OVERSCAN
TINT GAMMA
SHARPNESS
FILTER
SHARPNESS MODE
VIDEO TYPE
NOISE REDUCTION
5 COMP/RGB(YPrPb 15kHz) 5 COMP/RGB(RGB 15kHz)
6 COMP/RGB(YPrPb 15kHz)
6 COMP/RGB(RGB 15kHz)
5 COMP/RGB(YPrPb 32kHz) 5 COMP/RGB(RGB 32kHz)
6 COMP/RGB(YPrPb)
6 COMP/RGB(RGB)
7 COMP/RGB(YPrPb 15kHz) 7 COMP/RGB(RGB 15kHz)
8 COMP/RGB(YPrPb 15kHz)
8 COMP/RGB(RGB 15kHz)
7 COMP/RGB(YPrPb) 7 COMP/RGB(RGB)
8 COMP/RGB(YPrPb)
8 COMP/RGB(RGB)
9 GRAPHICS RGB
11 DVI-D (RGB)
12 HDMI
1 VIDEO
2 VIDEO
10 GRAPHICS RGB
11 DVI-D (YPrPb)
3 S-VIDEO
4 S-VIDEO
Some of these parameters may not be available for certain
inputs or certain input signals, in accordance with the definitions
in Tables 4 and 5.
Pressing the key on the remote control or the ◀ key on the
keypad (Fig.30) serves to activate the Memories management
menu page.
0 Auto
3 S MEMORIA 1
-EMORIES
Save current settings
Save initial settings
Rename
2 I
1 S
Fig.30
The available operations for each selected memory are
described below.
Saving a memory
To save the image parameter current values in memory 1,
move the cursor to line ‘1’ with the ▲ and ▼ keys and open
the pull-down menu by pressing the ◀ key (Fig.31). Select the
line Save current setting. To confirm the operation, the mes-
sage Current settings saved in Memory 1 is displayed at the
bottom of the screen and the letter S appears to the left of
the memory name. Memories 2 and 3 are saved using the
same procedure.
0 Auto
3 S MEMORIA 1
-EMORIES
Save current settings
Save initial settings
Rename
2 I
1 S
Fig.31
Recall memories
To retrieve memories select the required line and press the ▶ key.
The parameters stored in the selected memory will be applied
to the displayed image, while a confirmation message will be
displayed to confirm the operation Memory 1 recalled. The
retrieved memory is associated with the specific source and
signal type and called automatically whenever that specific
combination of source and signal type is selected.
ON-SCREEN MENU