Installation manual

18
C3X LINK
19
Inputs
1 VIDEO 1
2 VIDEO 2
3 S-VIDEO 3
4 S-VIDEO 4
5 COMP/RGB 5
6 COMP/RGB 6
7 COMP/RGB 7
8 COMP/RGB 8
9 GRAPH RGB 9
10 GRAPH RGB 10
11 DVI-D 11
12 HDMI 12
1
2
3
4
5 YPrPb 32kHz
6 RGBS 15kHz
7 YPrPb
8 YPrPb 15kHz
9
10
11 YPrPb
12
Inputs
1
2
3
4
5 YPrPb 32kHz
6 RGBS 15kHz
7 YPrPb
8 YPrPb 15kHz
9
10
11 YPrPb
12
YPrPb AutoSync
YPrPb 15kHz
YPrPb
RGB Auto Sync
RGB 15khz
RGB
1 VIDEO 1
2 VIDEO 2
3 S-VIDEO 3
4 S-VIDEO 4
5 COMP/RGB 5
6 COMP/RGB 6
7 COMP/RGB 7
8 COMP/RGB 8
9 GRAPH RGB 9
10 GRAPH RGB 10
11 DVI-D 11
12 HDMI 12
Fig.18a
Fig.18b
9 ON-SCREEN MENU
In the pull-down menu it is also possible to select the horizontal
frequency manually or use the AutoSync option; in this case
the system automatically recognises the input signal horizontal
frequency (15kHz, 32kHz or higher).
Input 11 can receive YPrPb or RGB signals from DVI-D sources.
The selection must be made on the pull-down menu following
the previously illustrated system.
After selecting the source signal (by means of the ▲ and ▼
keys), press MENU+/MENU - to confirm and close the pull-down
menu; the value you have just set will be displayed on the right
of the < symbol.
As with the other inputs, you can now select the input just set
by pressing the ▶ key.
During the short time it takes to find the signal, a box appears
showing the signal requested. As soon as the signal is shown
in the box additional information is displayed concerning the
video standard (for video signals) or resolution (for graphic
signals), and aspect.
In the SETUP menu you can select whether or not to display this
information; for further details refer to the SOURCE INFO item in
the MENU area in the ADDITIONAL INFORMATION section.
INPUTS
The input selection menu (Inputs) is called by pressing 0 on
the remote control and SOURCE on the keypad. To select an
input, scroll the list with the ▲ and ▼ keys until the desired input
is highlighted, then press ▶.
Display of the input selection menu is terminated by pressing the
ESC key or when the On-Screen Menu display timeout interval
(set in the Menu Setup) has elapsed.
Input 5 can receive RGB and YCrCb signals no higher than
32 kHz.
Inputs 6-7-8 can receive RGB and YCrCb signals, at 15 kHz, 32
kHz or higher. The association between the input and the type
of signal (RGB or YCrCb) is made from the pull-down menu
that appears on the right of the < symbol after pressing the ◀
key (Fig. 18b).
All system functions can be activated from the keypad or remote control with the aid of a practical and comprehensive system
of on screen menus.
ON-SCREEN MENU