Installation manual

C3X LINK

SWITCH ON FROM STAND-BY

Switching on the system (Fig.14):

• with the remote control ( )

• with the Projector keypad

Typically, the picture will appear after 15-20 seconds.

If the system is switched on very soon after it was last switched

off, the lamp may fail to come on because it is too hot. In this

case just wait a few minutes to allow the lamp to cool.

Switching off the system (Fig.15):

• with the remote control ( key)

• with the Projector keypad ( key).

If you wish to power off the system completely, wait at least three

minutes in stand-by before setting the mains power switches on

the units to the “O” position or disconnecting the power supply

cables. This is to allow the fans in the Projector unit sufficient

time to cool the lamp.

If power is disconnected from the Projector unit (e.g. setting

the mains power switch to the “O” position or inadvertently

unplugging the power cable), to restart the C3X-LINK system

also power-off the DigiOptic™ Image Processor unit and repeat

the power-up sequence described at points 1, 2, 3 and 4.

If the fibre optic link between the two units is interrupted (e.g.

by removing one or more cables) to restore normal system

operation switch off the two units by means of the mains power

switches, restore the fibre optic connections, and then repeat

power-up mode steps 1, 2, 3 and 4.

SWITCHING ON AND OFF