Installation manual

C3X LINK

To activate an electric motorised screen a 12 Volt output is pro-

vided at the rear of the DigiOptic™ Image Processor (Fig.10).

Fig.10

The output is activated (Voltage: 12 Vdc) when the projector is

switched on and is de-activated (no Voltage output) when the

projector is in stand-by mode.

In addition it is possible to install black motorised screen

masking systems for the screen when changing the aspect

of the projected image from 16:9 to 4:3 (Fig.11). The control

can be obtained from the output at the top on the back of

the DigiOptic™ Image Processor.

Fig.11

CLASS 1 LASER PRODUCT

CAUTION:

for continued

fire, replace

only with same type and rating fuse.

A TEXAS INSTRUMENTS TECHNOLOGY

Fig.7

Fig.8

Fig.9

Protective cap

Ferrule

Connector

Fibre

Cable

Separation point

Protective cap

• Make sure that the single optical cables are not switched:

the numbers on the cables must match the numbers on

the connectors.

• Check that the connectors are correctly inserted.

• Make sure that the cable does not constitute an obstacle

for persons moving around the room.

• Take care not to create knots in the cable; the minimum

radius of bends in the cable is 2 cm.

• Prevent the cable from pulling and mechanical stress: this

could cause the connectors to be pulled out and dama-

ged.

After removing the protective caps from the fibre optic cable

connectors and the panel connectors, insert the fibre optic

connectors carefully, matching the numbers shown on each

element (Fig.8-9). Be very carefully when handling fibre optics

and connectors.

INSTALLATION