LCD Flat Panel TV User And Installation Manual

21

8 ON-SCREEN MENU
All system functions can be activated from the keypad or remote
control with the aid of a practical and comprehensive system of on
screen menus.
INPUTS
The input selection menu is called by pressing 0 on the remote
control and, when no other menu is displayed, also using the
▲ and
▼ keys on the keypad. To select an input, scroll through the list with
the ▲ and ▼ keys until the required input is highlighted, then press
◀ . Display of the input selection menu is terminated by pressing
the ESC key or when the On-Screen Menu display timeout interval
(set in the MENU SETUP) has elapsed.
Input 5 can receive RGB and YCrCb signals no higher than 32
kHz.
Inputs 6-7-8 can receive RGB and YCrCb signals, at 15 kHz, 32 kHz
or higher. The association between the input and the type of signal
is made on the pull-down menu that appears on the right of the <
symbol after pressing the ◀ key (Fig. 21b).

  
 

 

 

 

 

 
 
 
  
 
 
     




  
  
 
  


 






  
  
 
  


 

 



 
 


  
 

 

  
 

  
 
 
 
  

 
 
     
In the pull-down menu it is also possible to select the horizontal
frequency manually or use the AutoSync option; in this case the
system automatically recognises the input signal horizontal frequency
(15KHz, 32KHz or higher). Input 11 can receive YCrCb or RGB signals
from DVI-D sources. The selection must be made on the pull-down
menu following the previously illustrated system.
After selecting the source signal (by means of the
▲ and ▼ keys),
press MENU+/MENU - to confirm and close the pull-down menu; the
value you have just entered will be displayed to the right of the <
symbol.
In general, the selection become operational for all inputs after
pressing the ▶ key.
Once the input has been selected, a brief phase starts during which
the system analyses the the applied signal. During this interval a
box appears with an indication relative to the signal requested. As
soon as the system locks on to the signal the picture is displayed
and a window appears containing information relative to the specific
video format and standard (for video signals) or the resolution (for
graphic signals).
In the SETUP menu you can select whether or not to display this
information; for further details refer to the “SOURCE INFORMATION”
heading in the “ MENU ” section.
MAIN MENU
To access the main On Screen Display menu, press the
MENU key on
the keypad or the MENU+ or MENU - key on the remote control.
The main menu is divided into four windows, PICTURE, IMAGE, SETUP
and MENU , in which the various adjustments are grouped according
to the frequency of use. Use the
▶ and ◀ keys to select the line
corresponding to the adjustment you wish to make (Fig. 22).
























Fig. 22
The various menus offer only the relevant adjustments in accordance
with the type of input signal displayed. For this reason, for example,
when the source is a graphic signal certain typical adjustments for
video signals do not appear on the menus, and vice versa when
the source is a video signal.
Fig. 21a
Fig. 21b