Instruction Manual

ManualsBrandsSilverStone ManualsPower suppliersST60F-PS

lssue date: July, 2012

NO.G11216750

SST-ST60F-PS

STRIDER PLUS SERIES

Smallest and most powerful modular ATX PSUs

Compact design with a depth of 140mm for easy integration

80 PLUS Silver certification with 80 PLUS Gold level efficiency at 230Vac

100% modular cables

24/7 continuous power output with 40℃ operating temperature

Class-leading single +12V rail

Strict ±3% voltage regulation and low ripple & noise

Silent running 120mm fan with 18dBA minimum

with 80 PLUS Silver

Summary of content (7 pages)

PAGE 1
STRIDER PLUS SERIES SST-ST60F-PS Smallest and most powerful modular ATX PSUs with 80 PLUS Silver lssue date: July, 2012 NO.
PAGE 2
STRIDER PLUS SERIES SPECIFICATION 2.3 Max. Input AC Current Max. Input Current Measuring Range 8A SilverStone Strider Plus ST60F-PS ATX12V / EPS 12V Switching Power Supply With Active PFC 80Plus Silver PS/2 90 - 264 Vrms 2.4 Inrush Current The power supply must meet inrush requirements for any rated AC voltage, during turn on at any phase of AC voltage, during a single cycle AC dropout condition, during repetitive ON/OFF cycling of AC, and over the specified temperature range.
PAGE 3
STRIDER PLUS SERIES 3.2 Remote On/Off Controlled mode The PSON# signal is required to remotely turn on/off the power supply, PSON# is an active low signal that turns on the output power rails. When this is not pulled low by the system, or left open, the outputs (except the +5VSB) turn off. This signal is pulled to a standby voltage by a pull-up resistor internal to the power supply. TTL level "H" 2.0 V - 5.25 V "L" 0.0 V – 1.0 V 3.
PAGE 4
STRIDER PLUS SERIES 4.2 Output Protection 4.2.1 Under voltage protection The +5V/+12V/+3.3V DC output are protected against the under voltage condition . range value can't be exceed 3.3~3.7V at 5V terminal and 8.5~9.5V at 12V, 2.0~2.4V at 3.3V. 4.2.2 Over Voltage Protection The +12V/ DC output are protected against the over voltage condition . Maximum value can't be over 15.5V at 12V. 4.2.
PAGE 5
STRIDER PLUS SERIES 8. Product Safety Time Diagram Figure 1 8.1 Safety Requirement AC ON AC 8.2 Leakage Current The AC leakage current is less than 3.5mA when the power supply connect to 264Vac/50Hz . AC OFF +5Vs PS-ON/OFF POWER ON POWER ON 4.75V 4.75V 8.3 Insulation Resistance The insulation resistance should be not less than 30M ohm after applying of 500VDC for 1 minute. 0.25V +5V O/P T4 T3 T5 T1 Power Good 8.
PAGE 6
STRIDER PLUS SERIES 12. Harmonics The product shall meet requirement for EN61000-3-2 & EN61000-3-3 :1995 standard of class D, test at 230Vac 50Hz. 13.Power Factor The power supply with active power factor correction, and meet the EN61000-3-2 standards, The power factor is greater than 0.9 at 230V/50Hz, Max. load.
PAGE 7
STRIDER PLUS SERIES Warranty Information 8PIN PCI Express connector Yellow Yellow Yellow Black sense1 This product has a limited 3 year warranty in North America, Europe, and Australia. For information on warranty periods in other regions, please contact your reseller or SilverStone authorized distributor. Signal Pin Pin Signal +12V +12V 1 2 5 6 COM COM Black Black +12V COM 3 4 7 8 COM COM Black Black 1.