User's Manual

11
SECTION TWO
Setting Up Your SilverCare
TM
System
(Using
Base Console )
CONNECT BATTERY PACK FOR FIRST USE
• Remove both screws from door of battery compartment
• Lift battery compartment door located on bottom of
Base Console, by placing finger or thumb under notch
provided
• Firmly connect NiMH battery pack wires into connectors,
paying careful attention to connecting with proper polarity
• Snap battery compartment door back into place, replace
screws, and the base is ready to set-up
Figure 1 Figure 2
Remove Battery Pack Cover Connect Battery Pack
Since the AC adapter is not yet connected the Base Console
screen will read
Reset
Date/
Time
Power Outage
Phone Line Out
Exit