Instructions / Assembly
Table Of Contents
- 1) SYSTEM & INSTALLATION OVERVIEW
- 2) ESTIMATING REQUIRED SILVERMINE MATERIALS
- 3) TRANSPORTING, STORING & HANDLING
- 4) RECOMMENDED TOOLS & EQUIPMENT
- 5) OTHER MATERIALS
- 6) PREPARING FOR INSTALLATION:
- 7) FASTENING
- 8) CUTTING
- 9) INSTALLING INITIAL COURSES:
- 10) SUBSEQUENT COURSES (WORKING YOUR WAY UP THE WALL)
- 11) SUPPLEMENTAL FLASHING & TRANSITIONS
- Step Flashing Defined
- Flashing & Installing Outside Corners
- Flashing & Installing Inside Corners
- Flashing Vertical Transitions
- Flashing Horizontal Cladding Transitions with Stone below
- Flashing Horizontal Cladding Transitions with Sills below
- Under Openings (Trim removable, Sills or Panels Below)
- Sills Under Windows w/out Removable Trim
- Under Fixed Trim Situations (trim not removable, tight eaves, frieze boards, etc.)
- Over Trimmed Openings
- Flashing Soffit Terminations
- Flashing & Installing Light and Electrical Boxes
- Flashing & Installing Vents
- 12) CARE & MAINTENANCE
- 13) DEALING WITH COMPLIMENTS
- APPENDIX A - STONE ESTIMATION SHEET
- APPENDIX B –DRAWINGS
- Fig. B-1 Flat Panel
- Fig. B-2 Initial Course Over Foundation Wall Base
- Fig. B-3 Initial Course Over Water Table Trim
- Fig. B-4 Outside Corner w/ Step Flashing
- Fig. B-5 Inside Corner w/ Step Flashing
- Fig. B-6 Vertical Transition w/ Step Flashing
- Fig. B–7 Panels Below Siding
- Fig. B–8 Panels Below Trim
- Fig. B–9 Sills Below Siding
- Fig. B-10 Panels/Sills Below Openings w/ Removable Trim
- Fig. B-11 Sills Below Window w/out Removable Trim
- Fig. B-12 Panels Under Fixed Trim
- Fig. B-13 Initial Course Above Trimmed Openings
- Fig. B-14 Panels Below Soffit
- Fig. B-15 Electrical & Light Box Installation
- Fig. B-16 Vent Installation
26
APPENDIX B - INSTALLATION DRAWINGS
Fig. B-6 Vertical Transition w/ Step Flashing
PANEL WITH FACTORY EDGE ELEVATION VIEW
PANEL
SEALANT
TRIM (NOTE: MATERIAL, SIZE, AND PROFILE MAY VARY)
SHEATHING
SAF
2"
OVERLAP
PANEL FLASHING
SAF 8" TALL MINIMUM. MUST
OVERLAP PANEL FLASHING BY 2"
SEALANT
PANEL WITH FACTORY EDGE PLAN VIEW
TOP OF FLASHING
FROM PRIOR PANEL
1/16" RECOMENDED EXPANSION GAP
1/16" RECOMENDED EXPANSION GAP
TRIM
BLOCKING AT
PANEL EDGE
HOUSEWRAP
PANEL