User's Guide

Blue-Bot

¥ Regularly examine for damage the plug, enclosure and other parts. In the event of any

damage, the toy and charger must not be used until the damage has been repaired.

¥ Exhausted batteries are to be removed from the product.

¥ The battery fitted to your Rechargeable Blue-Bot is a non-replaceable DC 3.7V 500 mAh,

Lithium Polymer rechargeable battery.

Care & Maintenance

¥ If necessary, wipe Blue-Bot gently with a clean damp cloth.

¥ Keep Blue-Bot away from direct sunlight and heat.

¥ Do not allow Blue-Bot to come into contact with water or other liquids. If painting or

gluing on the additional shells, ensure the shells are dry before clipping to Blue-Bot.

¥ In the event of a static discharge, Blue-Bot may malfunction. In this case, please

switch it off and then back on again to reset it.

Important Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) This device

must accept any interference received, including interference that may cause undesired

operation.

Warning: Changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.