Instruction Manual

8
GB
Maintenance
Cleaning
• Keep your machine clean at all times
• Always allow all water to drain from the pump before storing
• The Lance Nozzle (10) may get dirty or blocked over time, which will
effect operation. Clean the lance nozzle using the Cleaning Pin (16)
supplied. There is a storage slot for the cleaning pin on the rear of the
pressure washer top handle. A garden hose can also be used to clean
the nozzle by back-flushing water through the nozzle. Combining use
of the pin and back-flushing should allow the nozzle to be thoroughly
cleaned. The frequency of carrying out this task will depend on the water
quality in your area. Hard water areas require more frequent cleaning
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure,
or visible sparking
• If you suspect that the brushes may be worn, have them replaced at an
authorised service centre
Symptom Possible Cause Solution
No detergent suction Blockage in detergent bottle tube Clean with warm water
Smoke Overloaded or damaged motor Do not use. Contact dealer immediately
Pressure washer doesn’t start
Pressurized Squeeze trigger on gun before starting
Mains plug not fully inserted or mains socket switch is off Check and correct issue
RCD has operated or
not been reset
Reset RCD
Plug fuse has blown Replace fuse and contact dealer if it blows again immediately
Thermal safety switch has operated Switch off and allow pressure washer motor to cool before starting
Poor water spray pressure
Water inlet filter is clogged Clean filter
Water hose connection is leaking or allowing air to enter Check water hose connection
Pressure washer valves or seals are worn or damaged Contact dealer
Fluctuating water pressure
Pump is sucking in air Check water hose connections
Clogged nozzle See Maintenance for cleaning procedure
Motor stops suddenly Thermal safety switch has operated Switch off and allow to cool before restarting
Water leaking from pump Seals worn out Contact dealer
Troubleshooting
Storage
Always store this machine in a dry place that will not fall below 0˚C
Disposal
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools
102580_Z1MANPRO1.indd 8 09/08/2013 11:13