User guide

8
GB
Problem Possible Cause Solution
Material not blasting from gun
Pressure incorrect Set the correct air pressure according to the specification
Material hose clogged Remove rubber hose and remove blockages
Air blockage
Check air supply; disassemble and clean sandblasting gun
if necessary
Incompatible abrasive
(too coarse or too heavy)
Choose suitable abrasive
Clogged gun
Damp abrasive Replace with dry abrasive (damp material can be dried and reused)
Water in air supply Check compressor and filtration system
Incompatible abrasive
(too coarse or too heavy)
Choose suitable abrasive
Sputtering
Worn nozzle Replace nozzle
Abrasive build-up around nozzle Remove nozzle and clean
Air leak
Check all fittings and hose for air leaks and correct issue by
re-tightening, using PTFE tape or replacing
Tool will not stop after Trigger
(4) is fully released
Throttle valve O-ring or valve seat damaged Have the tool repaired at an authorised Silverline service centre
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
Troubleshooting
633629_Z1MANPRO1.indd 8 16/01/2014 11:03