User Manual

8
GB
Troubleshooting
Problem Cause Solution
Motor working but irregular or no
spraying
Feed tube within Paint Container (12) in wrong
position
Adjust position
Feed tube blocked Flush through with soapy water or thinners depending on blockage
Wrong setting of Air Volume Adjuster (3) Adjust to correct position
Nozzle (16) blocked Remove and clean
Blocked filter Check condition and replace if necessary
Atomization of spray is poor
Air volume setting incorrect Adjust setting
Paint too thick Check viscosity
Paint running or drips on surface
Too much paint applied Adjust air volume downwards
Paint too thin Check viscosity
Motor louder than normal
Spray Gun (2) not clean or possible blockage Disassemble Spray Gun and clean the Nozzle (16) and other parts with thinners
thoroughly
Turbine Unit (9) not working
No power Check Turbine Unit is switched on, and the power plug is correctly inserted into
the mains socket and switched on
Incorrect operating sound
Paint Container near empty causing air to be
sucked in
Refill with paint
Orange-peel effect on painted
surface
Paint too thick Check viscosity
Spray Gun incorrect distance from surface or poor
angle
Correct position
Incorrect solvent used with paint Use correct solvent
798866_Z1MANPRO1.indd 8 04/07/2013 11:09