Owner manual

8
GB
Problem Possible cause Solution
No function when On/Off Rocker
Switch (2) is operated
No power Check power supply
Defective On/Off Rocker Switch Have the On/Off Rocker Switch replaced by an authorised Silverline
service centre
Slow material removal
Sanding belt too fine or worn Fit new sanding belt with coarser grit
Scratches on workpiece after
sanding
Sanding belt too coarse Fit new sanding belt with finer grit
Not enough material removed Continue sanding
Burn marks on workpiece
Sanding belt incompatible with material Fit correct sanding belt
Too much pressure exerted on to the File Arm (8) Use less pressure whilst moving the machine
Belt slides off the File Arm (8)
when turning
Belt not installed correctly Follow instructions in ‘Fitting a sanding belt’
Worn or defective sanding belt; belt with wrong
dimensions
Fit a new sanding belt
Troubleshooting
Disposal
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools
247820_Z1MANPRO1.indd 8 27/11/2013 14:20