Owner's manual

Problem Possible cause Solution

Red and green LEDs do not illuminate to indicate the battery

is correctly charging

Battery not correctly connected to charger

Clean battery socket of charger and battery contacts and fully

slide on to charger so it clicks in a locked position

Charger not powered Recheck mains connection

Battery pack has low capacity

Battery not being fully charged Do not remove battery until a full charge is indicated

Battery pack has been charged over 100 times and capacity

has started to reduce

This is normal for battery packs. Contact your Silverline dealer

to purchase a replacement battery pack

Drill cannot be switched on (Trigger Switch (8) does not move)

The Forward/Reverse Switch may be in the middle (“locked”)

position

Slide the Forward/Reverse Switch either to the left or right

Drill does not start when Trigger Switch is depressed

Battery completely discharged Recharge battery or replace with a fully charged battery

Defective battery Replace battery

Drill machine defective Contact your Silverline dealer or authorised service centre

Screws do not reach deep enough into the workpiece

Not enough torque; torque clutch setting too low Choose a higher torque setting

Low battery voltage Recharge battery or replace with a fully charged battery

Screws are driven too deep into the workpiece surface Too much torque; torque clutch setting too high Choose a lower torque setting

Troubleshooting

241469_Z1MANPRO1.indd 8 12/12/2013 16:37