Instruction Manual

Problem Possible cause Solution

Router will not operate

No supply of power Check that power is available at source

Brushes worn or sticking

Disconnect power, open Brush Access Covers (4) & (20). and ensure

brushes are not damaged or heavily worn

Switch is faulty Contact an authorised repair agent

Motor components faulty or short circuited Contact an authorised repair agent

Router runs or cuts slowly

Blunt or damaged cutter Resharpen or replace cutter

Variable Speed Dial (5) set low Increase variable speed setting

Motor is overloaded Reduce pushing force on router

Makes an unusual sound

Mechanical obstruction Contact an authorised repair agent

Armature has shorted sections Contact an authorised repair agent

Excessive vibration Bent or damaged cutter Replace cutter

Heavy sparking occurs inside

motor housing

Brushes not moving freely Disconnect power, remove brushes, clean or replace

Armature short circuited or open circuited Contact an authorised repair agent

Commutator dirty Contact an authorised repair agent

Fine Adjustment Knob (14)

“clicks” or not adjusting

Plunge Lock Lever (15) engaged Release Plunge Lock Lever

Reached end of adjustment range Reset Fine Adjustment Knob and set depth with Depth Stop Wheel (2)

Troubleshooting

The following chart contains information designed to assist in diagnosing

and resolving router problems.

264895_Z1MANPRO1.indd 8 05/11/2013 12:17