Operation Manual

SSL 6 A1
GB
│
IE
│
45 ■
Troubleshooting
This section contains important information on fault identification and rectification. Follow
the instructions to avoid hazards and damage.
Fault Possible cause Remedy
The UV appliance 
cannot be switched
on.
The mains plug 3 is not
plugged in.
Plug the mains plug 3 into the
socket.
The mains power socket is
not supplying power.
Check the house fuses.
The 2-in-1 coator
the peel-off UV nail
polishare not
curing sufficiently.
Selected treatment time too
short.
Select a longer treatment time.
On or more of the LEDs
defective.
The UV LEDs cannot be
replaced. Contact the Customer
Service department.
You have applied too much
2-in-1 coator peel-off
UV nail polish.
Use less 2-in-1 coator peel-
off UV nail polish.
The nails were not positioned
correctly under the UV
LEDs.
Hold your hand correctly in the
UV appliance .
A dispersion layer
remains on the nails
after curing.
A dispersion layer is
formed due to polymeri-
sation.
Remove the dispersion layer
afterwards with a cleansing
pad.
A UV LED is not light-
ing up.
UV LED defective.
The UV LEDs cannot be
replaced. Contact the Customer
Service department.
NOTE
► If you are unable to resolve the problem by applying any of the methods mentioned
above, please contact the Customer Service department.