Operation Manual

SSL 6 A1
GB
│
IE
│
41 ■
Applying the peel-off polish
NOTE
► You can use the gel nails starter kit for your fingernails as well as your
toenails. Due to the roughness of toenails, it is possible that the polish
coat cannot be removed or only with difficulty. In this case, your toenails
must be filed off as with regular nail gel. A base coat of clear varnish
can help to achieve a better peel-off effect.
Ƈ Apply a thin coat of 2-in-1 coat  to your nails as a primer. Take care
not to touch the cuticle, as this can effect the durability. During applica-
tion, keep at a distance of around 1 mm from the cuticle.

If you accidentally get any 2-in-1 coat  on your cuticle, remove it
before it hardens, for example with a cotton wool bud.
NOTE
► To stop the 2-in-1 coat  from running into the nail edges, it can be
briefly hardened beforehand. To do this, hold each finger with the nail
facing upwards in the UV appliance  and press the 10 s or 30 s
button ( ).
► If you are using the gel nails starter kit for your pedicure, carefully hold
your entire forefoot in the UV appliance . You can completely remove
the base plate for this. See the section "Removing/attaching the base
plate".
Ƈ Harden the 2-in-1 coat for 60 seconds. To do this, hold four fingers
and then your thumb in the UV appliance  and press the 60 s button .