Operation Manual

■ 30
│
GB
│
IE SPDP 18 A1
♦ Remove the four screws from the headrest bracket clamp using a
Phillips screwdriver.
♦ Place the clamp of the headrest bracket around the headrest
supports and tighten with the four screws.
NOTE
► Depending on the diameter of your headrest supports, use either
the pre-assembled screws or the supplied long fixing screws

.
♦ Pass the securing strap

through the brackets on the back of the
DVD player
A
.
♦ Now press the angle bracket into the holder of the clamp until it is
fully engaged. Check that the angle bracket and the DVD player
A
are fitted securely.
♦ Undo the side screw on the angle bracket and set the desired
inclination angle of the DVD player
A
.
♦ Secure the position by tightening the side screw again.