Operation Manual

■ 28
│
GB
│
IE SPDP 18 A1
Setting up
Check package contents
(See fold-out page for illustrations)
DANGER
► Do not allow children to play with packaging materials.
There is a risk of suffocation!
♦ Remove all parts of the device and the operating instructions from
the box.
♦ Remove all packing materials and the protective films from the
screens.
♦ Remove the transport lock from the DVD drive.
The following components are included in the delivery:
▯ DVD player
▯ Second monitor
▯ Remote control
▯ 2 headrest brackets
▯ 2 securing straps
▯ 8 spare screws
▯ Mains adapter
▯ Car adapter
▯ AV/DC cable
▯ AV cable (3.5 mm jack plug to cinch)
▯ 2 x AAA/Micro batteries
▯ 2 earphones
▯ Transport bag
▯ Quick start guide
▯ These operating instructions
NOTE
► Check the package for completeness and signs of visible
damage.
► If the delivery is incomplete or damage has occurred as a result
of defective packaging or during transport, contact the customer
service hotline (see Service chapter).
Inserting/changing the remote control batteries
♦ Open the battery compartment

on the rear of the remote
control.
♦ Insert two AAA/Micro batteries into the remote control, as shown
in the battery compartment

.
♦ Close the battery compartment

again.
Connecting the power supply
In order to use the device, you must connect the power supply.
You can connect it to a mains socket or operate it using the integrated
rechargeable battery or the car adapter.
CAUTION
► Make sure that all devices are switched off before connecting
them. Do not switch on the devices until all connections have
been established.
Mains power operation:
♦ Insert the plug of the supplied mains adapter

into the DC IN
socket
$
on the side of the DVD player
A
.
♦ Plug the mains adapter

into a mains socket that is always within
easy reach.
Operation using the car adapter:
CAUTION
► The car adapter

is not suitable for use with a 24 V on-board
power socket.
♦ Insert the plug of the supplied car adapter

into the DC IN
socket
$
on the side of the DVD player
A
.
♦ Connect the car adapter

to a suitable 12 V on-board socket,
e.g. the car's cigarette lighter.
Charging the DVD player battery
Once you have connected the power supply, the integrated recharge-
able battery in the DVD player
A
will charge automatically. During
charging, the charging LED
#
lights up red. As soon as the battery is
fully charged, the charging LED
#
turns off.
NOTE
► If the DVD player
A
is not going to be used for some time, the
battery should be recharged at regular intervals to maintain
battery performance.