Operation Manual

SPBD 5000 A1
GB│IE│NI │ 13 ■
Handling and use
Charging mobile devices with the power
bank
♦ Connect the micro-USB plug on the charging cable
to the micro-USB port on the mobile device and the USB
plug to the USB socket (OUT) on the power bank. The
charging process starts automatically.
♦ If charging does not start automatically, press the ON/
OFF button briefl y to start the charging process.
NOTE
►
Alternatively, you can also use the original charging
cable (USB cable) provided by the respective device
manufacturer.
► Some devices cannot be charged due to the high start-
up charging current required (higher than 2.1 amps).
♦ During the charging process, the current Power Bank
charge level is shown via the charge level LEDs
(see
table in section entitled "Checking the charge level").
♦ To stop charging, disconnect the charging cable from
the mobile device and the power bank. The charge level
LEDs switch off .