Operation Manual

■ 20
│
GB
│
IE
│
NI
SKR 800 C3
Troubleshooting
This section contains important information about fault identification and rectifica-
tion. Follow the instructions to avoid hazards and damage.
Fault causes and remedies
The following table will help you to identify and rectify minor malfunctions:
Fault Possible cause Remedy
There is nothing on
the display
4.
The plug is not plugged in. Insert the power plug into the socket.
The mains socket is not
supplying power.
Check the house mains fuse.
The display is switched off
automatically or manually.
Press any button on the device.
No sound.
The volume is set to mini-
mum.
Increase the volume using the
−VOLUME+ |
/FUNC. 1 dial.
The device is in clock/stand-
by mode.
You can switch the device to radio
operation by pressing the
−VOLUME+ |
/FUNC. 1 dial.
The external playback
device is muted in AUX
operation.
Un-mute the external playback
device.
The audio cable
is incor-
rectly connected in AUX
operation.
Ensure that the audio cable is cor-
rectly connected to the AUX input
5
and the external playback device.
Interference with the
radio reception.
The reception is weak.
Try to improve the reception by
relocating the wire aerial
i.
Press and hold the
|
ST/MO
button
q for around 2seconds to
receive the station in mono.
The time, the date
and the station pre-
sets are reset after a
power failure.
There are no batteries in the
battery compartment
d or
the batteries are empty.
Check that the batteries are suffi-
ciently charged and replace them if
necessary.
The batteries have been in-
serted the wrong way round
in the battery compartment
d.
Check whether the batteries have
been inserted the right way round in
the battery compartment
d. When
doing so, note the polarity signs in
the battery compartment
d.
The time, the date and the station pre-
sets will need to be reprogrammed.