Operation Manual

│

11 ■

SKR 800 C3

Installation under a wall cupboard

3,1 cm

6,3 cm

Using the supplied mounting plate u, you can install the device e.g. under a

wall cupboard. Proceed as follows to mount the device:

♦ Slide the mounting plate

u to the rear and remove it from the device.

♦ Find a suitable installation location for the device (see also the section

"Requirements for the set-up location").

♦ Hold the mounting plate

u under the installation location. Ensure that the

front edge of the mounting plate u is approx. 3.1cm behind the front of

the cupboard so that the device is ﬂush with the cupboard after installation.

The side edges of the mounting plate u must be spaced approx. 6.3cm

away from adjacent cabinets or walls.

♦ Mark the 4 mounting points with a pencil.

♦ Using a pin or nail, make a small depression at the respective marking

points. In hardwoods, drill a shallow hole in the markings using a ∅ 2.5 mm

wood drill bit.

♦ If required, place the supplied spacers

f between the cupboard and the

mounting plate. If you are using the spacers provided f, you will need the

long mounting screws g.

♦ Screw the mounting plate u tight using the mounting screws provided (g

or h).

♦ With the top of the device against the mounting plate u, push the device

back until it clicks into place.

♦ Check to ensure that the device is ﬁrmly in position and safely route the

power cable

o and the wire aerial i.