Operation Manual

■ 50 │ GB│MT
SHMS 300 C2
Puréeing
WARNING! RISK OF INJURY!
► Never use containers made from glass or
other easily breakable materials. These con-
tainers may be damaged and cause injuries.
ATTENTION! PROPERTY DAMAGE!
►
Never use the blender ! for hard foodstuffs
such as: coffee beans, ice cubes, sugar, cereals,
chocolate, raw/hard vegetables etc. This could
result in serious damage to the appliance.
► Do not use the blender ! to purée boiling
food (e.g. soups). Remove the pot from the
hotplate before puréeing.
1) Use the blender ! to purée foods.
Kneading
hooks 0 for
kneading
heavy doughs,
e.g. yeast
dough.
Whisks .
for stirring
batter or cake
mixture or
for whipping
cream.
Blender !
for puréeing
fruits/
vegetables,
e.g. apples.
2) Open the safety catch of the blender socket 
by pushing it to the side and holding it firmly.
NOTE
► The blender ! can only be used if the whisks .
or the kneading hooks 0 are not installed.
3) Push the blender ! into the blender socket 
and push it down firmly. The blender ! must
audibly click into place.
4) To avoid overflowing, the container used for
blending should only be filled to about 2/3 of
its capacity. Select a suitably large container.
NOTE
► Ensure that there is a sufficient amount of
liquid/purée in the purée container.
To ensure effective mixing of the ingredients,
the food should cover at least the lower section
of the blender !.
► Do not switch the hand mixer on until the
blender ! has been inserted into the ingre-
dients.
5) Press the Turbo button /
. Keep the Turbo
button /
 pressed down during the whole
procedure. The appliance stops as soon as it
is released.
ATTENTION! PROPERTY DAMAGE!
► Do not operate the blender ! for longer
than 1 minute at a time. After one minute of
use, allow the appliance to cool down fully.
6) When you have finished working with the
blender !, release the Turbo button/
 and
remove the mains plug from the power socket.
ATTENTION! PROPERTY DAMAGE!
► Clean only the lower section of the blender !
under running water. Do not allow water to
get inside the blender !. This could result in
damage to the appliance.
7) To remove the blender ! from the blender
socket

, press the blender release button 
on both sides of the hand element - at
the same time. The blender ! is now released
from the blender socket 
.
8) Remove the blender ! with a snapping motion
from the blender socket 
.