Operation Manual

SED 3.7 E2

■ 12

│

5) Place the epilator perpendicular to the skin and, without exerting

any pressure, move it against the direction of the hair growth.

Thereby, the side with the speed switch  must face towards

you. Do not make back and forth or circular movements.

Always start anew and pass over the body part to be epilated

several times, so that all of the hair is removed.

NOTICE

► It may be that the hair grows back after a few days. The

reason for this is that these hairs were too short to be

removed during the last epilation session.

6) When you are ﬁnished with the treatment, place the speed switch 

to “0”.

7) Clean the epilator head  as described in the section “Cleaning

and Care”.

8) Replace the protective cap  on the epilator head .

NOTICE

► If the epilator head  is damaged, discontinue all further use!

To order a new epilator head , please contact the service de-

partment (see chapter “Guarantee and service”). Please have

the IAN number ready (see operating manual cover).

To replace the epilator head , please proceed as follows:

― Press the two restraint ﬁxtures  together and at the

same time pull the epilator head  upwards.

― Press the new epilator head  onto the appliance.

Ensure that the gears on the epilator head  and on

the appliance mesh with each other. The epilator head 

must audibly engage.