Operation Manual

│

9 ■

SDM 1500 C2

Handling and operation

This section provides you with important information on handling and using the

appliance.

Filling with water

CAUTION – PROPERTY DAMAGE!

► Never operate the appliance without water in the water tank 8!

The pump could overheat and be damaged!

1) Push the “Water tank” release button 9 downwards and simultaneously

pull the water tank 8 towards the rear and oﬀ the appliance with a tilt

movement.

2) Turn the water tank 8 and unscrew the cap.

3) Fill the water tank 8 with tap water up to the MAX mark.

NOTE

If the mains water in your location is rated as hard, it is recommended that

you mix the mains water with some distilled water. Otherwise, the jets for

the steam blast function could calcify (become blocked) prematurely.

To extend the optimal steam blast function, mix mains water with

distilled water according to the table:

Water hardness Ratio of distilled

water to

tap water

very soft/soft 0

medium 1:1

hard 2:1

very hard 3:1

The water hardness level can be queried at your local water works.

4) Attach and hand-tighten the clamp.

5) Turn the water tank 8 around again and place it back onto the main unit 3:

First ﬁt the lower part into the main unit 3 and then ﬂip the top part into the

device. Push it ﬁrmly into place so that the water tank 8 audibly clicks into

place and sits ﬁrmly on the main unit 3.