Operation Manual

7
SDBE 2600 A1
GB
IE
Plugging in and ironing
Dry ironing without steam is possible at all tempera-
tures, steam ironing is only possible from the setting
range on the temperature control 6.
■ Insert the plug into a mains power socket.
CAUTION! PROPERTY DAMAGE!
► If the clothing care instructions forbid ironing,
(
symbol), the clothing item may not be
ironed. Ignoring this warning could lead to
permanent damage to the clothing item.
■ Check the care instructions on the labels in
garments to see if the
y are suitable for being
ironed, and at which temperature setting.
Temperature
control
icon 6
Type of Material
Acrylic, rayon
Silk, wool,
polyester mix fabrics
Cotton, linen,
viscose
■ Select the appropriate temperature setting using
the temper
ature control 6.
NOTE
While it is heating up, always place the iron on
the base 9.
If y
ou place the iron down on its sole 0 and do
not move it, the automatic switch-off will be acti-
vated after 30 seconds (see chapter "Automatic
switch-off ") and the appliance stops heating.
The temperature control lamp 7 lights up. When
the control lamp 7 goes out, the set temperature
has been reached.
■ Wait until the temperature control lamp 7
goes out.
■ To moisten the laundry, press the spray
button
4.
This function is suitable for very dry and very
crumpled garments.
Steam ironing
■ Set the steam control 3 to the desired steam
setting.
■ The temperature control 6 must be set to at
least the setting . Otherwise no steam can
be produced.
Ironing with steam blast
The steam blast function is especially suitable for
smoothing diffi cult-to-reach parts of a garment.
■ Raise the steam iron slightly.
■ For a steam blast, press the steam blast
button
5.
Putting the steam iron down
RISK OF FIRE!
► Never leave a hot steam iron unattended if
it is switched on or connected to the mains
po
wer supply.
■ Move the temperature control 6 to the "MIN"
position.
■ Stand the steam iron only on the base 9.
IB_114193_SDBE2600A1_SE_NL.indb 7 09.07.15 16:00