Operation Manual

SDB 2400 F4
GB
│
IE
│

23 ■
Pausing operation of the steam iron
WARNING – RISK OF FIRE!
► Never leave a hot steam iron unattended if it is switched on or connected
to the mains power supply.
1) Move the temperature control 8 to the "MIN" position.
2) Stand the steam iron only on the base 0.
After use
■ Remove the plug from the mains power socket.
■ Empty the water tank and clean the sole of the iron q.
■ Place the cooled-down steam iron on the base 0.
Drip-stop function
With conventional steam irons, water can drip from the sole of the iron q at
low temperatures. This iron however, possesses a new feature, the DRIP-STOP
function. At low temperatures, the iron automatically switches off the steam-
blast function. When this happens, you will hear a "CLICK". Then set a suitable
temperature with the temperature control 8. As soon as this is reached, steam
production is resumed.
Automatic switch-off
This steam iron is fitted with an automatic switch-off system. This stops the iron
from heating up.
If the iron is resting on the sole of the iron q and is not moved for about 30
seconds, you will hear a warning beep and the control lamp for the automatic
switch-off 6 will flash. The iron will stop heating up. To deactivate the automatic
switch-off, lift up the iron and move it gently from side to side. The control lamp
for the automatic switch-off 6 goes out and the iron will heat up again.
If the iron is on its base 0 and is not moved for about 8 seconds, there will be a
warning beep and the control lamp for the automatic switch-off 6 flashes. The iron
will stop heating up. To deactivate the automatic switch-off, lift up the iron and
move it gently from side to side. The control lamp for the automatic switch-off 6
goes out and the iron will heat up again.
IB_295773_SDB2400F4_LB8.indb 23 17.10.17 16:48