Operation Manual
10
GB
When the safety shut-off is activated, an
alarm sounds for approx. 3 seconds and the
symbol |6 starts to flash until the function
is switched off.
Switching off the function
Pick up the steam iron by its handle|8 and
hold it horizontally for a few seconds or
make some ironing movements.
8. Cleaning
DANGER!
~ Pull the mains plug|10 out of the wall
socket before you clean the steam iron.
~ Allow the device to cool down before
cleaning.
CAUTION:
~ Do not use any astringent or abrasive
cleaning agents.
Cleaning the device
• For cleaning the device, use a soft,
moistened cloth.
• Dirt can be removed from the sole
plate|18 using commercially available
cleaning agents for chrome, silver or
stainless steel.
• Residues that have melted on can be re-
moved by heating the steam iron up to
the MAX setting and then ironing an
old cotton cloth.
Self-cleaning
CAUTION:
~ Do not put vinegar, limescale remover
or any other additives into the water
tank|13. Additives can damage the de-
vice.
If you use tap water, you should run the self-
cleaning cycle after every use. Otherwise
use the self-cleaning cycle at least twice per
month.
1. Fill the water tank|13.
2. Place the steam iron on the base
unit|12.
3. Connect the mains plug|10 with the
wall socket.
4. Set the steam flow rate controller|3 to
and set the temperature control-
ler|15 to MAX.
5. Wait until the temperature control lamp
|7 goes out.
6. While doing so, hold the device hori-
zontally over a heat-resistant household
dish.
7. Press the
|16 SELF CLEAN
button and
hold it down. Limescale residues will now
be ejected with steam and hot water from
the steam outlet holes in the sole plate|
18
.
Hold the button down until no more steam
or water emerges.
8. Repeat steps 1 to 7 until no more resi-
dues are coming out.
9. Pull out the mains plug|10, allow the
device to cool down, and pour off any
remaining water.
9. Storage
DANGER!
~
Store the steam iron out of the reach of
children.
1. Finish ironing, set the temperature con-
troller|15 to MIN and pull out the
mains plug|10.
2. Allow the device to cool down.
3. Set the steam flow rate controller|3 to
.
4. Pour off any remaining water through the
filler opening of the water tank (under
lid
|2
).
5. Store the iron in an upright position.
BB1$6B%XHJHOHLVHQB%ERRN6HLWH)UHLWDJ2NWREHU