Operation Manual

SBT 1.5 A1
■ 28
│
GB
│
IE
NOTE
► If...
– the shaving result deteriorates noticeably,
– the shave takes much longer than usual,
– there is any visible damage on the shaving head ,
... the shaving head  needs to be replaced.
► You can order replacement shaving heads  from our service
department (see section "Ordering replacement parts").
Removing and cleaning the shaving head
To clean the shaving head  thoroughly, you need to remove the
shaving head from the housing:
1) Remove the protective cap  (if fitted) from the housing.
2) Turn the shaving head in the opposite direction to the arrow
until the marking on the shaving head points to the O
marking on the housing.
3) Pull the shaving head  off the housing.
Clean the shaving head  using the supplied cleaning
brush  and/or rinse the shaving head  under running
water.
4) Dry off the shaving head  thoroughly if necessary.
5) Also remove any remaining hairs using the cleaning brush .
6) Replace the shaving head  on the housing and turn the shav-
ing head  in the direction of the arrow
until the marking
on the shaving head points to the marking on the housing.
7) Replace the protective cap  on the housing.
Dismantling the shaving head
You can also dismantle the shaving head  if you want to clean it
particularly thoroughly: