Operation Manual

GB
│
IE
│
NI
│
CY
│
13 ■
SAST 18 A1
Cleaning
ATTENTION! PROPERTY DAMAGE!
► Do not use aggressive, chemical or abrasive cleaning agents. These could
damage the outer surfaces of the appliance.
Emptying the dirt container and cleaning the filter
NOTE
► To achieve the best results, empty the dirt container % and clean the HEPA
filter 6 regularly.
1) If you have not already done so, disconnect the appliance from the mains
adapter  or lift it off the wall bracket .
2) To open the dirt container %, press the release button ! and remove the
dirt container % from the appliance.
3) Remove the filter holder 1together with the HEPA filter 6from the dirt
container % by pulling both straight out of the dirt container %.
4) Empty the dirt container %.
5) Remove the HEPA filter 6from the filter holder 1 by turning it anticlockwise
towards the
symbol and pulling it out.
6) Tap out the HEPA filter 6 and the filter holder 1 over a rubbish bin. If nec-
essary, you can rinse out the filter holder1 and the HEPA filter 6 with fresh
water. Before replacing the parts ensure that they are completely dry. Do not
dry the HEPA filter 6 with hot air.
7) Reinsert the filter holder 1 into the dirt container %. Make sure that the filter
holder 1 is straight and that the rubber lip seals the dirt container %.
8) Insert the HEPA filter 6into the filter holder 1so that the catches on the
HEPA filter 6fit into the corresponding recesses on the filter holder 1.
The arrow on the HEPA filter 6must be aligned with the arrow on the filter
holder 1. Turn the HEPA filter 6 clockwise towards the
symbol.
9) Replace the dirt container % on the motor unit .:
– First, place the contacts on the underside of the dirt container %onto the
contact pins on the underside of the motor unit .. This pushes the two
catches on the motor unit .into the recesses on the dirt container %.
– Press the upper side of the dirt container %against the upper side of the
motor unit . so that the catch audibly engages. The dirt container% is
now firmly seated on the motor unit ..