Operation Manual
■ 10
│
GB
│
IE
│
NI
│
CY
SAST 18 A1
■ Recharge the batteries again if the appliance’s suction power becomes
appreciably weaker and the charge indicator lamp 3 flashes green.
NOTE
►
If the charge indicator lamp 3flashes alternately green and red, the
batteries are fully discharged and the appliance will switch off after around
1 minute.
► The appliance can also be charged directly via the mains adapter . To
do this, remove the barrel plug from the wall holder with a slight twist
and insert it into the socket on the appliance.
► The appliance cannot be operated during charging.
Operation
ATTENTION!
► The suction opening must always be open and may not be blocked.
Blockages lead to overheating and damage to the motor.
► Use the wet-suction nozzle only at level I (low/wet suction
).
NOTES
► Make certain that the HEPA filter 6 is inserted before using the appliance.
► When vacuuming liquid, do not exceed the MAX marking in the dirt
container %.
► If the motorised brush attachment is blocked so that the brush can no
longer rotate, the appliance will switch off. The charge indicator lamp 3
flashes red and the working light 0 goes out. If this happens, remove the
blockage as in the section "Cleaning the brush attachment". To reactivate
the appliance, push the On/Off switch - to the "OFF" position and then
back into the mode that you want to use ("I" or "II").
1) Remove the appliance from the wall bracket or, if you are not using the
wall bracket , remove the barrel plug from the socket.
2) If required, place the appropriate nozzle in the suction opening. See section
"Using accessories".
3) To switch the appliance on, slide the On/Off switch - forwards into
position I (= low power/wet suction
) or position II (= high power).
The charge indicator lamp 3lights up yellow at level I, green at level II.
The working light 0 lights up.
4) To switch the appliance off, place the On/Off switch - back to the "OFF"
position. All lamps go out.