Operation Manual

9
SAR 28 A1
GB
IE
The connector for the antenna control voltage is available for a relay-controlled
antenna. The relay then automatically extends the antenna out when the device is
switched on. When switched off , the antenna retracts back in. This connector can
also be used to control an external amplifi er. For exact connector information,
please consult the operating instructions for the amplifi er.
Connection of an external amplifi er
Use the LINE OUT
27
audio cinch output to connect an external amplifi er.
To do this, following the operating instructions for the external amplifi er.
Connection of an external subwoofer
Use the orange SUBW
26
cinch output to connect an external subwoofer.
To do this, follow the operating instructions for the external subwoofer.
Connection diagram
1234
5678
1234
5678
ISO
A
ISO B
Installation
The device can be installed into any standard ISO mounting bay. In the event that
your vehicle does not have an ISO mounting bay, contact your local specialist
workshop, local dealer or the technical department of a general store.
NOTE
►
Connect up the cables before fi nally installing the device.
Ensure that it is plugged in properly and that the system works correctly.
External amplifi er
SubwooferAntenna
IB_106770_SAR28A1_LB3.indb 9 14.11.14 14:31