Operation Manual

■ 10
│
GB
│
IE
DB 1400 B2
Steam ironing
■ Set the steam control  to the desired steam setting.
The temperature control  must be set to at least the
setting. Otherwise
no steam will be produced.
NOTE
► After steam ironing or when no more steam is needed, set the steam control 
to the
position. Otherwise, water could drip from the sole of the iron .
Ironing with steam blast
The steam blast function is especially suitable for smoothing difficult-to-reach
parts of a garment.
1) Raise the steam iron slightly.
2) For a steam blast, press the steam blast button
.
Temporarily setting the steam iron down
CAUTION! RISK OF FIRE!
► Never leave a hot steam iron unattended if it is switched on or connected
to the mains power supply.
1) Move the temperature control  to the “MIN” position.
2) Stand the steam iron only on the base .
Taking the steam iron out of service
1) Remove the power plug from the mains power socket.
2) Empty the water tank and clean the sole of the iron .
3) Place the cooled-down steam iron on the base .