User Manual

6
8. As shown, insert one end of the fiberglass rod into the triangular pocket on the FRONT upper
outside corners of the net. The rod will then remain on the front of the net until it reaches the
second diagonal square from the lower inside corner as shown in Detail 8. Please push it
though this hole and down into the fiberglass rod pivot connector. Then carefully take the
fiberglass tube sleeve and slide it over the pivot connector as well. Do this for both sides.
Yard Guard
Detail 6
DO NOT DUNK ON THIS UNIT .
DO NOT HANG FROM ANY PART OF THIS
UNIT , INCLUDING THE BACKBOARD, RIM,
SUPPORT BRACES OR NET.
4L-8152-00
WARNING
!
*Rim
n
o
t sho
w
n
f
or c
l
ar
ity.
8
(Right)
7
(Left)
4L-8156-00
WARNI
NG
!
NOTE: Make sure
Warning Label and
artwork face FRONT.
7. Assemble both fiberglass rods (#5) and then
carefully push them through the Vinyl sleeves
(#9). See Detail 6 and Detail 7.
5
5
9
Pocket
Pocket
Figure 4
Second
diagonal
square
Detail 7
Detail 8